Dtc P0107: Manifold Absolute Pressure Circuit Low Input - Suzuki Grand Vitara 2011 Manual

1A-87 Engine General Information and Diagnosis: For Petrol Engine Model
DTC Troubleshooting
NOTE
Before this trouble shooting is performed, read the precautions for DTC troubleshooting referring to
"Precautions for DTC Troubleshooting: For Petrol Engine Model".
Step
1 Was "Engine and Emission Control System Check"
performed?
2 MAP sensor and its circuit check
1) Connect scan tool to DLC with ignition switch turned
OFF.
2) Turn ON ignition switch.
3) Check DTC.
Is there DTC P0107 or DTC P0108?
3 MAP sensor output signal check
1) Check MAP sensor according to "Manifold Absolute
Pressure (MAP) Sensor Inspection: For Petrol Engine
Model in Section 1C".
Is it in good condition?
4 MAP sensor circuit check
1) Check MAP sensor circuit referring to Step 3 to 6 of
"DTC P0107: Manifold Absolute Pressure Circuit Low
Input: For Petrol Engine Model" or Step 3 to 8 of "DTC
P0108: Manifold Absolute Pressure Circuit High Input:
For Petrol Engine Model".
Is circuit in good condition?
5 Air intake system check
1) Check air intake system for clog or leak.
Is it in good condition?

DTC P0107: Manifold Absolute Pressure Circuit Low Input

Wiring Diagram
Refer to "DTC P0106: Manifold Absolute Pressure Range / Performance: For Petrol Engine Model".
DTC Detecting Condition and Trouble Area
DTC detecting condition
Manifold absolute pressure sensor output voltage is lower
than 0.2 V for 0.5 sec continuously.
(1 driving cycle detection logic)
NOTE
When DTC P0532 and P1501 are indicated together, it is possible that "GRY/RED" wire circuit open.
DTC Confirmation Procedure
1) Connect scan tool to DLC with ignition switch turned OFF.
2) Turn ON ignition switch and clear DTC using scan tool and warm up engine completely.
3) Run engine at idle speed for 1 min.
4) Check DTC and pending DTC.
Action Yes
Go to Step 2.
Go to applicable DTC
diag. flow.
Go to Step 4.
Go to Step 5.
Substitute a known-
good ECM and recheck.
Trouble area
• Manifold absolute pressure sensor circuit
• Manifold absolute pressure sensor
• ECM
No
Go to "Engine and
Emission Control
System Check: For
Petrol Engine Model".
Go to Step 3.
Faulty MAP sensor.
Repair or replace.
Repair or replace.
S6JB0A1114022