Voip; Voip Testing - Avaya G450 Cli Reference Manual

Roadmap

VoIP

Table 102: VoIP CLI commands
Command
campon-busyout voip-dsp
reset voip-dsp
show voip-dsp
show voip-parameters

VoIP testing

Table 103: VoIP testing CLI commands
Command
busyout voip-dsp
release voip-dsp
show voip-parameters
test voip-dsp
144 Avaya G450 CLI Reference
Description
Put the entire VoIP engine or individual DSP childboard
in busyout (not available) state for maintenance or
firmware upgrade
Reset a VoIP DSP childboard on the motherboard
Display information about the DSP and DSP cores
parameters, status and occupancy
Display information about the VoIP engine
Description
Put the VoIP engine in busyout (not available) state. This is
recommended before starting a Bit Transfer Rate (BTR) test.
Release the VoIP entity from a busyout (not available) state.
This command also ends a running Bit Transfer Rate test.
Display information about the VoIP engine
Start a BTR test on the VoIP engine or a VoIP subsystem