Log-Adjacency-Changes - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

log-adjacency-changes

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
For IS-IS adjacencies:
log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
no log-adjacency-changes
For OSPFv3 adjacencies:
[ no ] log-adjacency-changes [ severity { severityValue | severityNumber } ]
[ verbosity verbosityLevel ]
Command introduced before JunosE Release 7.1.0.
Generates a log message when the state of an IS-IS adjacency or an OSPFv3 neighbor
changes. For OSPFv2 neighbors, use theospf log-adjacency-changes command.
Manipulates the same log as the Global Configuration log commands. The no version
disables this function.
severity—Sets minimum severity of the log messages for this category; described either
by a descriptive term—severityValue—or by a corresponding number—severityNumber—in
the range 0–7. The lower the number, the higher the priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
verbosity—Specifies the verbosity of this log category's messages
verbosityLevel—Specifies the verbosity of the log category's messages; can be any of
the following:
high—Verbose
low—Terse
medium—Moderate detail
Router Configuration
Chapter 12: L Commands
1231