Installation And Commissioning; Introduction To Installation And Commissioning - ABB CRB 1300 Product Manual

Hide thumbs Also See for CRB 1300:

Table of Contents

3 Installation and commissioning

This chapter contains assembly instructions and information for installing the CRB

1300 at the working site.

See also the product manual for the robot controller.

The installation must be done by qualified installation personnel in accordance

with the safety requirements set forth in the applicable national and regional

standards and regulations.

Safety information

Before any installation work is commenced, all safety information must be observed.

There are general safety aspects that must be read through, as well as more specific

safety information that describes the danger and safety risks when performing the

procedures. Read the chapter

Product manual - CRB 1300

3HAC083111-001 Revision: B

Always connect the CRB 1300 and the robot to protective earth and residual

current device (RCD) before connecting to power and starting any installation

For more information see:

Product manual - OmniCore C30

Product manual - OmniCore C90XT

3 Installation and commissioning

3.1 Introduction to installation and commissioning

Safety on page 15

before performing any installation