Separating the tubular
1
2
Separating the tubular support
1
2
Separating the tilt unit
1
Product manual - CRB 1300
3HAC083111-001 Revision: B
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Remove the tubular and tilt unit from the extender
unit.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Remove the tubular support.
Tip
If the tubular support is hard to loosen from the
tubular, use a plastic hammer to knock on the tu-
bular support lightly.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
© Copyright 2022-2023 ABB. All rights reserved.
5.5.3 Replacing the tubular and tilt unit
Note
xx2000001739
Note
xx2000001740
Note
Continues on next page
5 Repair
Continued
447