ABB CRB 1300 Product Manual page 395

2
3
4
Removing the axis-4 mechanical stop slider
1
2
Product manual - CRB 1300
3HAC083111-001 Revision: B
Action
Support the weight of the extender unit (only for
CRB 1300-7/1.4 and ), tubular and tilt unit, and
remove the screws.
Valid for CRB 1300-11/0.9 and CRB 1300-10/1.15
Separate the tubular from the housing.
Valid for CRB 1300-7/1.4 and
Separate the extender unit from the housing.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
Access the axis-4 mechanical stop slider from the
housing.
Put it aside for later refitting.
© Copyright 2022-2023 ABB. All rights reserved.
5.5.2 Replacing the housing and extender unit
Note
xx2000001729
xx2000001728
xx2000001727
Note
xx2000001732
5 Repair
Continued
Continues on next page
395