Manipulator Collapses On Power Down - ABB CRB 1300 Product Manual

7.4 Manipulator collapses on power down

Description
The manipulator is able to work correctly while Motors ON is active, but when
Motors OFF is active, one or more axes drops or collapses under its own weight.
The holding brakes (normally one in each motor), is not able to hold the weight of
the manipulator arm.
Consequences
For a heavy robot, the collapse can cause severe injury to personnel working in
the area or severe damage to the robot and/or surrounding equipment.
For a small robot, the collapse can cause injury to personnel working close to the
robot or damage to the robot and/or surrounding equipment.
Possible causes
The symptom can be caused by:
Recommended actions
The following actions are recommended:
1
2
3
4
Product manual - CRB 1300
3HAC083111-001 Revision: B
• Faulty brake.
• Faulty power supply to the brake.
Action
Determine which motor(s) causes the robot
to collapse.
Check the brake power supply to the col-
lapsing motor during the Motors OFF state.
Remove the resolver or resolver cover of
the motor to see if there are any signs of
oil leaks.
Remove the motor from the gearbox to in-
spect it from the drive side.
© Copyright 2022-2023 ABB. All rights reserved.
7 Troubleshooting
7.4 Manipulator collapses on power down
Information
See the circuit diagram.
If found faulty, the motor must be replaced
as a complete unit.
If found faulty, the motor must be replaced
as a complete unit.
695