ABB CRB 1300 Product Manual page 119

Modify a configuration
Use the following procedure to modify a loaded configuration and apply it to the
robot controller.
Product manual - CRB 1300
3HAC083111-001 Revision: B
3.7.4.1 The SafeMove configurator app on FlexPendant
2 Select Template configuration.
xx2200000447
3 Review that the template configuration is suitable for the intended application.
If modifications are needed, see
Note
A SafeMove configuration must always be validated to verify that the desired
safety is achieved. If no validation is performed, or the validation is
inadequate, the configuration cannot be relied on for personal safety.
4 If the template configuration is suitable, select Write to controller.
The safety report is presented on the screen.
5 Save the safety report. Print out and sign this safety report.
See ABB Safety Configuration Report on page
the safety report and how to validate is described in Application
manual - Functional safety and SafeMove.
6 Select Apply to controller to proceed.
The controller is automatically restarted when applying the configuration.
1 Select Enable Edit Mode to edit the safety configuration.
2 If no configuration is loaded, load an empty configuration or a template
configuration.
3 To add or modify an encapsulation, tap Add and select a geometry for Robot
Encapsulation or Tool Encapsulation.
To modify the encapsulation, select it and modify the attributes.
4 To add or modify a zone, tap Add and Add Zone.
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
Modify a configuration on page
124. More information about
Continues on next page
Continued
119.
119