ABB CRB 1300 Product Manual page 462

5 Repair
5.5.3 Replacing the tubular and tilt unit
Continued
Refitting the axis-5 timing belt
1
2
3
4
Reconnecting the CP/CS cabling (if equipped)
1
Continues on next page
462
Action
Install the timing belt to the pulleys and verify that
the belt runs correctly in the grooves of the pul-
leys.
Move the motor to achieve proper belt tension.
Use a sonic tension meter to measure the timing
belt tension.
If the timing belt tension does not meet the require-
ment, loosen the motor screws and readjust.
Secure the motor with the screws.
Action
Insert the male header of the connectors to the
connector plate.
© Copyright 2022-2023 ABB. All rights reserved.
Note
xx2000001595
Used belt: 59.3-63.4 Hz
New belt: 70.8-74.3 Hz
Tightening torque: 6 Nm
xx2000001594
Note
xx2000001537
Product manual - CRB 1300
3HAC083111-001 Revision: B