ABB CRB 1300 Product Manual page 564

5 Repair
5.7.2 Replacing the axis-2 gearbox
Continued
9
10
Jogging the robot to zero position
1
2
3
Removing the covers
1
Continues on next page
564
Action
Remove and clean the pipe after the oil is
drained.
Note
There will be some oil left in the gearbox
after draining.
Refit oil plugs.
Action
Turn on the electric power to the robot.
If the robot is not connected to the controller,
power must be supplied to the connector R1.MP
according to Supplying power to connector R1.MP
on page 66.
Jog all axes to zero position.
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safeguarded
space.
Action
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
© Copyright 2022-2023 ABB. All rights reserved.
Note
Tightening torque: 10 Nm
Note
xx2000001520
Note
Product manual - CRB 1300
3HAC083111-001 Revision: B