Updating Revolution Counters; Updating Revolution Counters On Omnicore Robots - ABB CRB 1300 Product Manual

6.3 Updating revolution counters

6.3.1 Updating revolution counters on OmniCore robots

Introduction
This section describes how to do a rough calibration of each manipulator axis by
updating the revolution counter for each axis, using the FlexPendant.
Step 1 - Manually running the manipulator to the synchronization position
Use this procedure to manually run the manipulator to the synchronization position.
1
2
3
Step 2 - Updating the revolution counter with the FlexPendant
Use this procedure to update the revolution counter with the FlexPendant
(OmniCore).
1
2
3
4
5
6
7
Product manual - CRB 1300
3HAC083111-001 Revision: B
6.3.1 Updating revolution counters on OmniCore robots
Action
Select axis-by-axis motion mode.
Jog the manipulator to align the synchron-
ization marks.
When all axes are positioned, update the
revolution counter.
Action
On the start screen, tap Calibrate.
Select Calibration from the menu.
The Mechanical Units page displays a list of available mechanical units.
Note
This step is required only if you are not already in the Mechanical Unit page when
you open Calibrate.
Note
The Mechanical Unit page is displayed only if there are more than one mechanical
unit available. Otherwise, the calibration summary page for the available mechanical
unit is displayed.
Select the mechanical unit for which revolution counter need to be updated.
The calibration summary page for the selected mechanical unit is displayed.
Calibration method used at factory for each axis is shown, as well as calibration
method used during last field calibration.
Tap Calibration Methods on the right pane.
The calibration options are displayed.
Tap Revolution Counters.
In the Selection column select the axes for which revolution counters need to be up-
dated.
© Copyright 2022-2023 ABB. All rights reserved.
6 Calibration
Note
See Synchronization marks and synchron-
ization position for axes on page
Step 2 - Updating the revolution counter
with the FlexPendant on page
Continues on next page
667.
669.
669