Maintenance; Introduction - ABB CRB 1300 Product Manual

Hide thumbs Also See for CRB 1300:

Table of Contents

4 Maintenance

Structure of this chapter

This chapter describes all the maintenance activities recommended for the CRB

It is based on the maintenance schedule found at the beginning of the chapter.

The schedule contains information about required maintenance activities including

intervals, and refers to procedures for the activities.

Each procedure contains all the information required to perform the activity,

including required tools and materials.

The procedures are gathered in different sections and divided according to the

maintenance activity.

Safety information

Observe all safety information before conducting any service work.

There are general safety aspects that must be read through, as well as more specific

safety information that describes the danger and safety risks when performing the

procedures. Read the chapter

The maintenance must be done by qualified personnel in accordance with the

safety requirements set forth in the applicable national and regional standards and

regulations.

Product manual - CRB 1300

3HAC083111-001 Revision: B

If the CRB 1300 is connected to power, always make sure that the CRB 1300 is

connected to protective earth and a residual current device (RCD) before starting

any maintenance work.

For more information see:

Product manual - OmniCore C30

Product manual - OmniCore C90XT

Robot cabling and connection points on page

Safety on page 15

before performing any service

4 Maintenance

4.1 Introduction