ABB CRB 1300 Product Manual page 103

ii
iii Contact ABB for more information if to use the (R1)R2.C3 connection for an application with a
Connector kits (optional)
Connector kits, base
R1.C1 and R1.C2 connectors on the base are parts of the CP/CS cable and Ethernet
floor cable, respectively. For details about the robot cabling, see
and connection points on page
Customers need to do wiring when using the R1.C3 connector on the base. Make
sure to use the R1.C3 connector in M12 A-code 4p female type.
Connector kits, tubular
The table describes the CP/CS and Ethernet (if any) connector kits for tubular.
Position
Connector
kits
Protection covers
Protection covers for water and dust proofing
Protection covers are delivered together with the robot and must be well fitted to
the connectors in any application requiring water and dust proofing.
Product manual - CRB 1300
3HAC083111-001 Revision: B
If the lead-through device is installed, the C2 connector will be used for the lead-through device
and 6 wires are occupied.
higher voltage.
Description
CP/CS R2.C1
R2.C3
Ethernet R2.C2
© Copyright 2022-2023 ABB. All rights reserved.
3 Installation and commissioning
3.5.2 Customer connections
98.
M12 CPCS Male straight
connector kits
M12 CPCS Male angled con-
nector kits
M12 CPCS Male straight
connector kits
M12 CPCS Male angled con-
nector kits
M12 Ethernet CAT6a Male
straight connector kits
M12 Ethernet CAT6a Male
angled connector kits
Continued
Robot cabling
Art. no.
3HAC066098-001
3HAC066099-001
3HAC068412-001
3HAC068413-001
3HAC067413-001
3HAC067414-001
Continues on next page
103