ABB CRB 1300 Product Manual page 305

6
7
8
9
Refitting the swing support
1
Product manual - CRB 1300
3HAC083111-001 Revision: B
Action
Fit the small circular plate of the axis-2 sealing
assembly tool and fix with three M6x75 screws.
Screw the screws, little by little and evenly, to
press the sealing into place.
Remove the assembly tool.
Check that the sealing is undamaged and properly
fitted.
Action
Check the sealing ring.
Replace if damaged.
© Copyright 2022-2023 ABB. All rights reserved.
5 Repair
5.4.2 Replacing the swing
Continued
Note
Small circular plate of the axis-2
sealing assembly tool, included in
Special toolkit for IP67 robots
(3HAC078203-001).
xx2000002470
xx2000002471
Note
Sealing ring, swing support side:
3HAC065676-001
Screw: M4x12 12.9 Lafre
2C2B/FC6.9 (16 pcs)
Tightening torque: 3.8 Nm
xx2000001692
Continues on next page
305