Table of Contents
Advertisement
5 Repair
5.5.1 Replacing the lower arm
Continued
3
4
5
6
Continues on next page
358
Action
Check the O-ring.
Replace if damaged.
Apply lubricating oil to the motor that has contact-
ing area with the gearbox.
Orient the motor correctly and fit it into the swing.
Make sure the motor is properly fit to gearbox.
Refit the screws and washers.
© Copyright 2022-2023 ABB. All rights reserved.
Note
O-ring on motor unit: 3HAC061327-
037
xx2000001629
Kyodo Yushi TMO150:
3HAC032140-001
xx2000001701
Motor orientation: orient the motor
according to the figure below, in
regard to the encircled motor con-
nector.
xx2000001630
Screw: M6x20 12.9 Gleitmo
603+Geomet 500 (4 pcs)
Tightening torque: 10 Nm
xx2000001626
Product manual - CRB 1300
3HAC083111-001 Revision: B
Advertisement
Table of Contents
Troubleshooting
