Cleaning Activities; Cleaning The Crb 1300 - ABB CRB 1300 Product Manual

Hide thumbs Also See for CRB 1300:

Table of Contents

4 Maintenance

4.3 Cleaning activities

4.3.1 Cleaning the CRB 1300

To secure high uptime it is important that the CRB 1300 is cleaned regularly. The

frequency of cleaning depends on the environment in which the manipulator works.

Different cleaning methods are allowed depending on the type of protection of the

Special cleaning considerations

This section specifies some special considerations when cleaning the robot.

Cleaning methods

This following table defines what cleaning methods are allowed for ABB

manipulators depending on the protection type.

Continues on next page

Always verify the protection type of the robot before cleaning.

Turn off all electrical power supplies to the robot before starting the cleaning.

Always use cleaning equipment as specified. Any other cleaning equipment

may shorten the life of the robot.

Always check that all protective covers are fitted to the robot before cleaning.

Do not point the water jet at connectors, joints, sealings or gaskets.

Do not use compressed air to clean the robot.

Do not use solvents that are not approved by ABB to clean the robot.

Do not remove any covers or other protective devices before cleaning the

Cleaning method

Wipe with cloth

Rinse with water

Yes. With light

Yes. It's highly re-

cleaning deter-

commended to in-

spect the fans for

contamination that

could hinder the air

supply at the regu-

lar cleaning, and

then clean if neces-

High pressure water,

steam or spray

Product manual - CRB 1300

3HAC083111-001 Revision: B