Safety During Installation And Commissioning - ABB CRB 1100 Product Manual

1 Safety

1.4 Safety during installation and commissioning

1.4 Safety during installation and commissioning
National or regional regulations
The integrator of the robot system is responsible for the safety of the robot system.
The integrator is responsible that the robot system is designed and installed in
accordance with the safety requirements set forth in the applicable national and
regional standards and regulations.
The integrator of the robot system is required to perform a risk assessment.
Layout
The robot integrated to a robot system shall be designed to allow safe access to
all spaces during installation, operation, maintenance, and repair.
If robot movement can be initiated from an external control panel then an emergency
stop must also be available.
Consider exposure to hazards, such as slipping, tripping, and falling.
Hazards due to the working position and posture for a person working with or near
the robot shall be considered.
Hazards due to noise emission from the robot needs to be considered.
Allergenic material
See
in the product, if any.
Securing the robot to the foundation
The robot must be properly fixed to its foundation/support, as described in the
respective product manual.
When the robot is installed at a height, hanging, or other than mounted directly on
the floor, there will be additional hazards.
Electrical safety
Incoming mains must be installed to fulfill national regulations.
The power supply wiring to the robot must be sufficiently fused and if necessary,
it must be possible to disconnect it manually from the mains power.
The power to the robot must be turned off with the main switch and the mains
power disconnected when performing work inside the controller cabinet. Lock and
tag shall be considered.
Harnesses between controller and manipulator shall be fixed and protected to
avoid tripping and wear.
Wherever possible, power on/off or rebooting the robot controller shall be performed
with all persons outside the safeguarded space.
Continues on next page
28
Environmental information on page 700
Note
Use a CARBON DIOXIDE (CO
© Copyright 2021-2023 ABB. All rights reserved.
for specification of allergenic materials
) extinguisher in the event of a fire in the robot.
2
Product manual - CRB 1100
3HAC078007-001 Revision: J