Battery Dismounting And Remounting; Water Pump And Generator Drive Belt Removal And Installation (For M16 Engine) - Suzuki Grand Vitara 2011 Manual

Battery Dismounting and Remounting

WARNING
!
When handling battery, following safety
precautions should be followed:
• Hydrogen gas is produced by battery. A
flame or spark near battery may cause the
gas to ignite.
• Battery fluid is highly acidic. Avoid spilling
on clothing or other fabric. Any spilled
electrolyte should be flushed with large
quantity of water and cleaned immediately.
Dismounting
1) Disconnect negative cable.
2) Disconnect positive cable.
3) Remove retainer.
4) Remove battery.
Handling
When handling battery, the following safety precautions
should be followed:
• Hydrogen gas is produced by battery. A flame or
spark near battery may cause the gas to ignite.
• Battery fluid is highly acidic. Avoid spilling on clothing
or other fabric. Any spilled electrolyte should be
flushed with large quantity of water and cleaned
immediately.
Remounting
1) Reverse removal procedure.
2) Tighten battery cables securely.
NOTE
Check to be sure that ground cable has
enough clearance to hood panel by terminal.
2
4
1
1. Battery
2. Positive cable
3. Negative cable
S6JB0A1A16002
5
6
3
I5JB0A1A0007-01
4. Body ground bolt
5. Retainer
6. Nut
Charging System: For Petrol Engine Model 1J-7
Water Pump and Generator Drive Belt Removal
and Installation (For M16 Engine)
Removal
1) Disconnect negative cable at battery.
2) If vehicle equipped with A/C, remove compressor
drive belt before removing water pump belt (1).
Refer to "P/S Pump and A/C Compressor (If
Equipped) Drive Belt Removal and Installation
(M16A Engine Model) in Section 6C".
3) Loosen drive belt adjusting bolt (2) and generator
pivot bolt (3).
4
2
3
4) Loosen water pump and generator drive belt
adjuster bolt (4) to displace generator and then
remove water pump belt.
Installation
1) Install belt (1) to water pump pulley (2), crankshaft
pulley (3) and generator pulley (4).
2) Adjust belt tension by referring to "Water Pump and
Generator Drive Belt Tension Inspection and
Adjustment (For M16 Engine): For Petrol Engine
Model".
3) If vehicle equipped with A/C, install compressor drive
belt referring to "P/S Pump and A/C Compressor (If
Equipped) Drive Belt Removal and Installation
(M16A Engine Model) in Section 6C".
4
4) Connect negative cable at battery.
S6JB0A1A16003
1
I5JB0A1A0001-01
2
1
3
I5JB0A1A0002-01