Water Pump And Generator Drive Belt On-Vehicle Inspection; Water Pump And Generator Drive Belt Removal And Installation - Suzuki 2006 SX4 Service Manual

Water Pump and Generator Drive Belt On-Vehicle Inspection

• Inspect belt for cracks, cuts, deformation, wear and cleanliness. If any of these conditions are found, replace belt,
referring to "Water Pump and Generator Drive Belt Removal and Installation".
• Check to make sure that tension indicators are as follows in the figure by using mirror.
a. If the tension indicator "B" is found to the left of the indicator "A", replace the generator belt.
b. If new generator belt has been installed, indicator "A" should be within "a" of the figure.
If it isn't, it means that belt is not installed properly.
Reinstall it properly.
1. Water pump and generator drive belt
2. Crankshaft pulley
Water Pump and Generator Drive Belt Removal
and Installation
Removal
WARNING
!
Disconnect negative (–) cable at battery
before removing and installing generator
belt.
1) Hoist vehicle.
2) Remove right side engine under cover.
3) Loosen tensioner by turning the tensioner pulley (2)
clockwise.
4) While holding the tensioner and belt loose, remove
generator belt (1).
3. Water pump pulley
4. Tension pulley
S6RW0C1A06004
Charging System:
5. Tensioner
6. Power steering pump pulley
3. Tensioner pulley bolt
1J-8
S6RW0C1A06003
I5JB0A1A0010-01
I3TR011A4001-01