Water Pump / Generator Drive Belt Removal And Installation; Water Pump Removal And Installation - Suzuki Liana RH413 Service Manual

1F-11 Engine Cooling System:
3) If belt is too tight or too loose, adjust it to proper
tension by displacing generator position.
4) Tighten generator adjusting bolt and pivot bolts as
specified torque.
Tightening torque
Generator adjusting bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
Generator pivot bolt (b): 50 N·m (5.0 kgf-m, 36.0
lb-ft)
5) Connect negative cable at battery.
Water Pump / Generator Drive Belt Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Remove right side engine under cover and generator
cover (if equipped).
3) Loosen drive belt adjusting bolt (2) and generator
pivot bolt (3).
When servicing car equipped with A/C, remove
compressor drive belt before removing water pump
belt (1).
Refer to "P/S Pump Drive Belt Removal and
Installation in Section 6C".
2
3
4) Slacken belt by displacing generator and then
remove it.
I2RH0B160013-01
S3RH0A1606019
1
I2RH0B160014-01
Installation
1) Install belt (1) to water pump pulley (2), crankshaft
pulley (3) and generator pulley (4).
When servicing car equipped with A/C, install
compressor drive belt, too.
4
1
3
2) Adjust belt tension by referring to "Water Pump /
Generator Drive Belt Tension Inspection and
Adjustment".
For adjustment of compressor drive belt tension,
refer to "P/S Pump Drive Belt On-Vehicle Inspection
in Section 6C".
3) Tighten water pump belt adjusting bolt and pivot bolt
to specified torque.
Tightening torque
Generator adjusting bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
Generator pivot bolt (b): 50 N·m (5.0 kgf-m, 36.0
lb-ft)
4) Install right side engine under cover and generator
cover (if equipped).
5) Connect negative cable at battery.

Water Pump Removal and Installation

Removal
1) Disconnect negative cable at battery.
2) Drain cooling system by loosening drain plug of
radiator referring to "Cooling System Flush and
Refill".
3) Remove A/C compressor belt referring to "P/S Pump
Drive Belt On-Vehicle Inspection in Section 6C" (if
equipped).
2
I2RH0B160015-01
I2RH0B160013-01
S3RH0A1606014