Changing The Default Management Pvc Vlan Id To Other Than 1 Or 0 - ZyXEL Communications MSC1024G Series User Manual

4.4 Changing the Default Management PVC VLAN ID to Other
than 1 or 0
This tutorial assumes that you have done the configuration described in Section
want to use a VLAN ID other than 1 or 0 for the management PVC settings (see
page 88). Normally, you may want to change the management VLAN ID because you want to
implement this IES to an existing network.
In this tutorial, IES-1 and IES-2 are connected through a TDM network. Subscribers are
connected to IES-2 in the remote (RT) site and IES-1 is connected to the Internet in the
central office (CO) site. The inband management VLAN ID and IP address of IES-1 and IES-
2 are 1000/192.168.1.1 and 1000/192.168.1.2. An EMS management computer (M) is
connected to the IES-1's Ethernet port 2 using an IP address of 192.168.1.250.
Figure 39 Subscriber Connection Test
CPE
Before you configure the MGTPVC, you have to make sure the follows:
1 No matter IES-1 or IES-2, make sure the inband management VLAN ID configured in
Sys > IP Setup is 1000.
2 In the CO site, if traffic between IES-1 and M is VLAN-tagged, make sure that you
have configured VLAN ID 1000 in the IES-1. To configure this:
Click VLAN > VLAN.
Select Enable, type a name and enter 1000 in VID.
Select Fix and Tag on Ethernet port 2 (enet2) where the EMS is connected.
Then click Apply.
MSC1000G/1024G/1224G Series User's Guide
RT
IES-2
in band: 192.168.1.2
IES-2
CO
IES-1
TDM
inband: 192.168.1.1
Chapter 4 Tutorials
4.3 but you
Figure 38 on
M
192.168.1.250
Internet
IES-1
89