Chapter 21 acl Commands
21.12.2 acl pppoeagent enable Command
Syntax:
acl pppoeagent enable <vid>
This command turns on PPPoE line information for subscribers in the specified VLAN. The
switch adds line information to PPPoE discover packets for user authentication and
identification.
The following example activates the PPPoE agent setting for VLAN 10.
ras> acl pppoeagent enable 10
21.12.3 acl pppoeagent delete Command
Syntax:
acl pppoeagent delete <vid>
This command removes PPPoE line information setting for the specified VLAN.
21.12.4 acl pppoeagent disable Command
Syntax:
acl pppoeagent disable <vid>
This command sets the switch to not add line information in PPPoE discover packets.
21.12.5 acl pppoeagent info Command
Syntax:
acl pppoeagent info <vid> <description>
This command specifies the PPPoE line information the switch is to add to PPPoE discover
packets from the specified VLAN. Enter a description (up to 24 alphanumerical characters).
Before you can configure PPPoE agent information, you must first create a
entry using the
608
acl pppoeagent set
command.
MSC1000G/1024G/1224G Series User's Guide