Multicast Bandwidth Port Commands; Multicast Bandwidth Port Disable Command; Multicast Bandwidth Port Enable Command; Multicast Bandwidth Port Set Command - ZyXEL Communications MSC1024G Series User Manual

where
<index>
<start-
mcast-ip>
<end-mcast-
ip>
<bandwidth>
This command configures bandwidth allocation for the multicast channel(s). For multicast
channel(s) for which you have not configured bandwidth settings, the default multicast
bandwidth setting applies (refer to
The following example sets the bandwidth allowed for the specified multicast channels to
1000 Kbps.
ras> multi band set 1 230.230.1.1 230.230.1.10 1000

30.3 multicast bandwidth port Commands

Use these commands to configure multicast bandwidth limitation on specified ports.

30.3.1 multicast bandwidth port disable Command

Syntax:
multicast bandwidth port disable <slot-port>
This command deactivates multicast bandwidth settings of the specified port.

30.3.2 multicast bandwidth port enable Command

Syntax:
multicast bandwidth port enable <slot-port>
This command activates multicast bandwidth setting on the specified port.

30.3.3 multicast bandwidth port set Command

Syntax:
multicast bandwidth port set <slot-port> <bandwidth>
This command sets the bandwidth allowed for multicast traffic on the specified port(s).
This following example sets the multicast bandwidth limit to 1000 kbps on port 1 on the line
card in slot 3.
ras> multicast bandwidth port set 3-1 1000
MSC1000G/1024G/1224G Series User's Guide
= A unique number for this setting.
The start of the multicast address range.
=
= The end of the multicast address range. For one multicast address, enter
the start multicast address again.
Allowed bandwidth between 1 and 1000 000 kbps (kilo bits per second).
=
Section 30.2.1 on page
Chapter 30 multicast Commands
672).
673