ZyXEL Communications MSC1024G Series User Manual page 246

Managment switch card

Hide thumbs Also See for MSC1024G Series:

Table of Contents

Chapter 11 Subscriber Port Setup Screens

Figure 148 SHDSL Port Setup

The following table describes the fields in this screen.

Table 98 SHDSL Port Setup

SHDSL Profile

Select the number of a line card's slot. The corresponding subscriber port setup

screen for the type of line card you selected automatically displays.

Select the number of a DSL port on the line card.

Click Load to display the port's settings in the fields below.

Select this check box to turn on this port.

Select a profile of SHDSL settings (such as the transfer rate, wire pair and signal

to noise ratio settings) to assign to this port. Use the SHDSL Profile screen to

configure SHDSL port profiles.

Note: All the SHDSL ports in an n-wire group must use the same

Select an alarm profile to define the thresholds that trigger an alarm on the port

when exceeded. This alarm profile is for the whole span. This is the entire

connection including any SHDSL regenerators that might be located between the

STU-C (SHDSL Termination Unit - Central) and STU-R (SHDSL Termination Unit -

Remote) end points. An SHDSL regenerator amplifies the SHDSL signal in order

to increase the connection distance.

MSC1000G/1024G/1224G Series User's Guide

Troubleshooting

Msc1224g series Msc1000g series