Mac Filter Slot Screen - ZyXEL Communications MSC1024G Series User Manual

Table 21 MAC Filter (continued)
LABEL
Mode
MAC1~10
Apply
Cancel
ID
State
Card Type
Up Time
Firmware

5.7.1 MAC Filter Slot Screen

Click the slot number of an active line card in the MAC Filter screen to display the screen
shown next.
Figure 53 MAC Filter: Slot
The following table describes the labels in this screen.
Table 22 MAC Filter: Slot
LABEL
UP
Port
Mode
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select accept to only allow frames from MAC addresses that you specify and
block frames from other MAC addresses.
Select deny to block frames from MAC addresses that you specify and allow
frames from other MAC addresses.
Type a device's MAC address in hexadecimal notation (xx:xx:xx:xx:xx:xx, where x
is a number from 0 to 9 or a letter from a to f) in this field. The MAC address must
be a valid MAC address.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
This is the slot number of a line card. Click the index number of an active line card
to display the MAC Filter Slot screen where you can view MAC filtering settings
on the specified line card.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974 for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Click UP to go back to the previous screen.
This field displays the number of the DSL port.
This field displays the filter action.
Chapter 5 Access Control List Screens
111