12.3 Before You Begin
• Make sure all frames have either one or two VLAN tag(s) for multiple service providers to
differentiate their own traffic. You have to configure the VLAN settings for xDSL and the
MSC management line cards.
• Make sure E1 lines are physically connected properly to an IMA line card.
• Make sure you have enabled TLS (see
for traffic before configuring a tagged PVC in the IMA > PVC screen for the traffic.
12.4 The IMA Group Setup Screen
Click IMA > GROUP in the navigation panel to open the following screen. Use this screen to
configure IMA group settings. You must configure the Minlink, Clk, Sym and Frame
settings to be the same as the remote IMA device.
Figure 199 IMA Group Setup
The following table describes the fields in this screen.
Table 133 IMA Group Setup
LABEL
Slot
Group
Load
Enable
MSC1000G/1024G/1224G Series User's Guide
Figure 142 on page 239
DESCRIPTION
Select the number of an IMA line card's slot.
Select the number of an IMA group on the line card.
Click Load to display the selected IMA group's settings.
Select this to enable the selected IMA group. Otherwise, clear this to disable it.
Chapter 12 IMA Screens
or
Figure 187 on page
294)
311