C
H A P T E R
This chapter shows you how to use the
parameters.
The ip commands are for management purposes, rather than for user traffic.
28.1
Commands Summary
ip
The following table lists the
administrator privilege level needed to use the command (H for high, M for middle or L for
low).
Table 319 ip Commands
COMMAND
ip
arp
gateway
ping
route
show
MSC1000G/1024G/1224G Series User's Guide
ip
commands. The P column on the right indicates the
ip
flush
show
<ip-
address>
<ip-
address>
[<count>]
delete
<dst-ip>[/
<netmask>]
<gateway-ip>
set
<dst-ip>[/
<netmask>]
<gateway-ip>
[<metric>]
[<name>]
show
ip Commands
commands to configure the IP (Internet Protocol)
DESCRIPTION
Clears the device's IP Address
Resolution Protocol (ARP) table.
Displays the device's IP ARP table.
Sets the default gateway IP address.
Pings a host (default 3 times)
count: number of pings.
Removes a routing table entry.
Adds or modifies a route entry.
a gateway IP address
gateway-ip:
of '0.0.0.0/0' means a default gateway.
Displays the routing table.
Displays the IP addresses of the in-
band and out-of-band management
interfaces and the default gateway, as
well as the in-band management VLAN
ID.
28
P
M
L
M
L
M
M
L
L
657