Ipbpvc Vlan Setup Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 11 Subscriber Port Setup Screens
Table 111 IPBPVC (continued)
LABEL
State
Card Type
Up Time
Firmware

11.19.1 IPBPVC VLAN Setup Screen

Use this screen to configure a IPB PVC's VLAN settings.
To open this screen, click Port > IP Bridge > IPBPVC and then the index number of an IPB
PVC.
Figure 167 IPBPVC: VLAN Setup
The following table describes the labels in this screen.
Table 112 IPBPVC: VLAN Setup
LABEL
UP
VPI/VCI
VID
Registration
Tag
272
DESCRIPTION
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This
could be due to the card starting, a firmware upgrade in progress or a
malfunction. See Section 39.7 on page 974
stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Click UP to go back to the previous screen.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify a IPB PVC (a channel).
Type the VLAN ID to which this channel belongs. This VLAN ID must be in an IP
bridge domain.
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Select the check box to tag all frames transmitted on this PVC with the port's
VID.
for what to do if the line card stays
MSC1000G/1024G/1224G Series User's Guide