Port Copy Screen - ZyXEL Communications MSC1024G Series User Manual

Chapter 11 Subscriber Port Setup Screens
The following table describes the fields in this screen.
Table 104 PVC Setup: PVLAN
LABEL
UP
VPI / VCI
VID
Etype
Priority
Apply
Cancel
Modify
Delete
The table in the bottom half of the screen lists the PVLANs of which the PVC is a member.
Index
VPI / VCI
VID
Etype
Priority
Select
Modify
Delete

11.13 Port Copy Screen

Click Port > Copy in the navigation panel to open the following screen. Use this screen to
copy subscriber port, VLAN and PVC settings from one DSL port to another DSL port or
ports.
258
DESCRIPTION
Click this to return to the previous screen.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify the channel.
Type a VID (VLAN ID) to add this channel as a member.
This must be the VLAN ID of a VLAN that is already configured. The port that you
are configuring must also be set to the fixed status in the VLAN.
Enter 4 digits in hexadecimal for Ethernet type which specify a protocol traffic. For
example, 0806 is the Ethernet type, 0x0806, for ARP (Address Resolution
Protocol) traffic.
Enter the priority level for the protocol VLAN. "0" is the lowest priority level and "7"
is the highest.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Click Modify to display the selected VLAN membership entry's settings in the
fields above so you can edit them.
Click Delete to remove the selected VLAN membership entry.
This is the number of the VLAN membership entry.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI). The VPI and VCI identify the channel.
This field displays the number of the VLAN (VLAN ID) of which this channel is a
member.
This field displays the Ethernet type of the VLAN of which this channel is a
member.
This field shows the priority of the VLAN of which this channel is a member.
Select the radio button of a VLAN membership entry and then use the Modify
button or the Delete button.
Click Modify to display the selected VLAN membership entry's settings in the
fields above so you can edit them.
Click Delete to remove the selected VLAN membership entry.
MSC1000G/1024G/1224G Series User's Guide