Port Enet Ratelimit Command; Port Enet Show Command; Port Enet Tls Commands - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
The following example sets the PVID of port 5 on the ELC in slot 4 to 76.
ras> port enet pvid 4-5 76

31.10.11 port enet ratelimit Command

Syntax:
port enet ratelimit <slot-port> <rate-limit_profile>
This command sets the specified Ethernet port(s) to use a profile that limits egress and ingress
rates.
The following example sets port 13 on the ELC in slot 7 to use a rate limit profile named test.
ras> port enet ratelimit 7-13 test

31.10.12 port enet show Command

Syntax:
port enet show <slot-port>
This command displays the settings for the specified Ethernet subscriber port(s). An example
is shown next for port 5 on the ELC in slot 4.
ras> port enet show 4-5
slot-port
pvid
priority
frametype
flowCtrl
ingress rate
egress rate
vlan setting:
vid port
----- ----- -------- --------
76 4-5

31.10.13 port enet tls Commands

Syntax:
port enet tls disable <slot-port>
port enet tls enable <slot-port>
port enet tls set <slot-port> <svid> <spriority>
port enet tls show <slot-port>
where
<svid>
<spriority>
714
:4-5
:76
:3
:all
:disable
:0 kbps
:0 kbps
adv untag
fix untag
Sets the service provider ID (from 1 to 4094) to add to received frames.
=
= Sets the IEEE 802.1p priority level (from 0 to 7) for the service provider's
VLAN ID.
MSC1000G/1024G/1224G Series User's Guide