where
<997|998>
A. Band plan 997 is not supported at the time of writing.
This command sets the band plan the VDSL port(s) uses.
The following example shows the configuration of port 5 on the VDSL card in slot 4 for an
asymmetric connection.
ras> port vdsl frequencyplan 4-5 998
31.34.5 port vdsl inpmin Command
Syntax:
port vdsl inpmin <slot-port> <us-inp> <ds-inp>
where
<us-inp>
<ds-inp>
This command configures impulse noise protection settings on a VDSL connection.
The following example sets the upstream noise protection at 1 DMT on traffic on port 5 on the
VDSL card in slot 4.
ras> port vdsl inpmin 4-5 us-inp 10
31.34.6 port vdsl ipqos Command
Syntax:
port vdsl ipqos <slot-port> <profile>
where
<profile>
This command configures QoS (quality of service) settings on a line card's port.
The following example sets QoS according to settings configured in the profile named
"qosprofile1" on traffic on port 5 on the VDSL card in slot 4.
ras> port vdsl ipqos 4-5 qosprofile1
MSC1000G/1024G/1224G Series User's Guide
=
Selects a band plan to use. For symmetric connections, use
asymmetric connections, enter
=
us-inp, ds-inp: The upstream and downstream impulse noise
protection setting. Input 0~160 to set the DMT level to 0.1 of the input value.
For example, an input value of 10 sets the actual DMT value to 1. Input
values 1~4 (0.1~0.4 DMT) are not valid.
=
The IP QOS profile specified using the profile ipqos command.
Chapter 31 port Commands
998
.
A
997
.
For
745