Alarm Vdsl2 Profile Setup - ZyXEL Communications MSC1024G Series User Manual

Table 155 Alarm VDSL Profile (continued)
LABEL
Apply
New
Cancel
The bottom part of the screen lists the configured profiles.
Index
Name
Modify
Delete

13.16 Alarm VDSL2 Profile Setup

Alarm profiles define alarm thresholds for VDSL ports on VLCs that follow the VDSL2 MIB
(defined in draft-ietf-adslmib-vdsl2-06). The device sends an alarm trap and generates a syslog
entry when the thresholds of the alarm profile are exceeded.
Click Profile > Alarm VDSL2 in the navigation panel to display the screen as shown. Use this
screen to view, add, edit, and delete VDSL alarm profile templates. One VDSL alarm profile
template specifies one VDSL line alarm profile and one VDSL channel alarm profile.
Figure 224 Profile > Alarm VDSL2
The following table describes the labels in this screen.
Table 156 Profile > Alarm VDSL2
LABEL
Name
Line Alarm Profile
Line Chan Profile
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh
profile without saving your changes.
Click Cancel to start configuring the screen again.
This is the index number of the alarm profile.
This is the name of the alarm profile.
Select a profile's Select radio button and click Modify to edit the profile.
Select a profile's Select radio button and click Delete to remove the profile.
DESCRIPTION
Enter a descriptive name for identification purposes.
Select a line alarm profile for this VDSL alarm profile template. You can configure
line alarm profiles by clicking the LineProfile link in the top-right corner of the
screen.
Select a channel alarm profile for this VDSL alarm profile template. You can
configure channel alarm profiles by clicking the ChanProfile link in the top-right
corner of the screen.
Chapter 13 Profile Screens
357