Acl Pktfilter Commands; Acl Pktfilter Set Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 21 acl Commands
This command displays the OUI filtering status (V for enabled, - for disabled) and the OUI
value(s) of the MAC address on a line card's specified DSL port(s) or on all of the line card's
DSL ports if no port is specified. The following example displays the OUI filter setting of port
1 on the line card in slot 3.
ras> acl ouifilter show 1-1
port mode
----- ------ ------ -----------------
1- 1 accept

21.11 acl pktfilter Commands

Use the following packet filter commands to filter out specific types of packets on specific
ports.

21.11.1 acl pktfilter set Command

Syntax:
acl pktfilter set <slot-port> <type>
where
<type>
606
enable mac address
-
Accept all packet types.
= accept-all:
pppoe-only: Accept only PPPoE packets and reject all other packet types.
(Point-to-Point Protocol over Ethernet) relies on PPP and Ethernet. PPPoE is a
specification for connecting the users on an Ethernet to the Internet through a
common broadband medium, such as a single DSL line, wireless device or cable
modem.
Alternatively, you can have the system reject any combination of the following
packet types (separated by a space).
Reject IP packets. Internet Protocol. The underlying protocol for routing
ip:
packets on the Internet and other TCP/IP-based networks.
Reject ARP packets. Address Resolution Protocol is a protocol for
arp:
mapping an Internet Protocol address (IP address) to a physical computer
address that is recognized in the local network.
dhcp: Reject DHCP packets. Dynamic Host Configuration Protocol
automatically assigns IP addresses to clients when they log on. DHCP
centralizes IP address management on central computers that run the DHCP
server program. DHCP leases addresses, for a period of time, which means that
past addresses are "recycled" and made available for future reassignment to
other systems.
eapol: Reject EAPol packets. EAP (Extensible Authentication Protocol, RFC
2486) over LAN. EAP is used with IEEE 802.1x to allow additional authentication
methods (besides RADIUS) to be deployed with no changes to the access point
or the wireless clients.
pppoe: Reject PPPoE packets.
MSC1000G/1024G/1224G Series User's Guide