Vlan Show Command - ZyXEL Communications MSC1024G Series User Manual

where
<vid>
<giga-port>
fix|forbid|normal
tag|untag
This command adds or modifies an entry in the static VLAN table.
The following example creates a static VLAN entry for VLAN 27 with the subtending 1 port
as a fixed member and it tags all frames going out through the port.
ras> vlan set 27 sub1 fix tag

36.3.6 vlan show Command

Syntax:
vlan show [<vid>]|[<start-vid> <end-vid>]
where
[<vid>]|[<start-
vid> <end-vid>]
This command shows information about the specified VLAN's settings. It displays the settings
of all of the VLANs if you do not specify a VLAN.
The following example shows the settings for all VIDs.
ras> vlan show
vid uplink
----- ----------------- ---------- -------------------------------
1 FFFF/UUUU
20 ----/TTTT
30 ----/TTTT
MSC1000G/1024G/1224G Series User's Guide
= The VLAN ID [1 – 4094].
This represents Gigabit Ethernet uplink ports, subtending ports or all
=
ports. Use sub1|sub2|up1|up2|all i
Use
sub|up|all
= fix: Makes the port a permanent member of this VLAN group.
: Prohibits the port from joining this VLAN group.
forbid
normal : The port can dynamically join this VLAN group using GVRP.
This is available for the Ethernet ports.
You cannot change a port from the fixed state to another state if the
port's PVID is set to this VLAN.
The VLAN must have at least one port set to the fixed status if the
VLAN is the CPU (management) VLAN.
= tag: Add an IEEE 802.1Q tag to frames going out through this
port(s).
untag : Send frames out through this port(s) without an IEEE 802.1Q
tag.
= You can specify a single VID: <1>, or a range of VIDs: <6> <10>.
1234567890 name
XFXFFF F 1
XXXXXX X 20
XFXXXX X 30
Chapter 36 vlan Commands
f trunking is not enabled.
if trunking is enabled.
935