ZyXEL Communications MSC1024G Series User Manual page 104

Chapter 5 Access Control List Screens
Figure 48 Downstream Broadcast
The following table describes the labels in this screen.
Table 17 Downstream Broadcast
LABEL
Slot
Port
Load
Add disabled
VLAN
Apply
Index
VLAN ID
Delete
Apply
Cancel
104
DESCRIPTION
Use the drop-down list boxes to select an DSL port on an active line card for which
you want to configure downstream broadcast blocking.
Click Load to display the port's current settings.
Specify the number of a VLAN (on this port) to which you do not want to send
broadcast traffic.
Note: The VLAN must already be configured in the system and the
port must be one of its members already
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
This is the number of the downstream broadcast blocking entry.
This field displays the number of a VLAN to which you do not want to send
broadcast traffic (through the specified port).
Select one or more entries' check boxes and then use the Apply button to remove
it (or them). Use the Select All check box to select all of the entries for the
specified line card's port.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
MSC1000G/1024G/1224G Series User's Guide