Ima Group Commands - ZyXEL Communications MSC1024G Series User Manual

Table 318 ima Commands (continued)
COMMAND
show

27.3 ima group Commands

Syntax:
ima group clk set <slot-gid> [ctc local]|[ctc loop]|[itc]
where
ctc local
ctc loop
itc
This command sets the source of the clock which the IMA should use for the E1 port(s) in the
selected IMA group.
Syntax:
ima group frame <slot-gid> 32|64|128|256
This command sets the number of ATM cells the IMA converts into a frame for the specified
IMA group.
Syntax:
ima group framesync <slot-gid> <alpha> <beta> <gamma>
where
alpha
beta
gamma
Syntax:
ima group link <slot-gid> <linklist>
MSC1000G/1024G/1224G Series User's Guide
show <slot>|<gid>|<slot
-group-vpi/vci>
= Select this to have all E1 ports in this group follow the IMA's clock.
= Select this to have all E1 ports in this group follow the remote connected
ADM device's clock.
= Select this to have each E1 port use its own clock. That means, the time
between two E1 ports might be different.
1~2, this is the number of received consecutive invalid ICP cells that will
=
cause the IMA line card to change the link state to inactive.
1~5, this is the number of received consecutive error ICP cells that will
=
cause the IMA line card to change the link state to inactive.
1~5, this is the number of received consecutive valid ICP cells that will
=
cause the IMA line card to change the link state to active.
Chapter 27 ima Commands
DESCRIPTION
Displays all IMA PVC settings for the
specified IMA slot, IMA group, or IMA
group with a channel.
Displays the MGT PVC to VLAN
mappings for each slot.
P
L
L
649