The following example turns on per-VLAN isolation for VLAN 5.
ras> switch isolation vlan set 5
ras> switch isolation show
port isolation :disabled
isolated vlan list:
----
5
938
34.9 switch mac aging Commands
Syntax:
switch mac aging set <aging time>
switch mac aging show
where
aging time
Use these commands to configure and display the MAC aging out time period. This is how
long all dynamically learned MAC addresses remain in the MAC address table before they age
out (and must be relearned). This setting applies to both the MSC and any installed ELCs.
The following example displays the current MAC aging out period and then changes it to 500
seconds.
ras> switch mac aging show
Aging time : 300
ras> switch mac aging set 500
34.10 switch mstp Commands
Use the
switch mstp
34.10.1 switch mstp cfgname Command
Syntax:
switch mstp cfgname <config name>
where
<config name> = A unique name (up to 31 characters) that identifies an MST region.
This command sets the switch to belong to the specified MST region.
MSC1000G/1024G/1224G Series User's Guide
Enter a number of seconds from 10 to 10,000. Enter 0 to disable the
=
aging out of MAC addresses.
commands to configure multiple spanning tree settings on the system.
Chapter 34 switch Commands
889