Sys User Server Command - ZyXEL Communications MSC1024G Series User Manual

Chapter 35 sys Commands
where
<mode>
This command sets which database the system uses to authenticate a user.
The following example sets the system to check a user's username and password against the
local database.
ras> sys user auth 1

35.6.2 sys user server Command

Syntax:
sys user server <ip-address> <port> <secret> [high|middle|low|deny]
where
<ip-address>
<port>
<secret>
[high|middle|
low|deny]
This command sets a RADIUS server's IP address, port number and the password to access
the server. This command also sets the default account privilege assignment if the RADIUS
server does not send the service type information after user authentication is successful.
You will be blocked access to the system for remote management if you enter
and the system uses only RADIUS authentication with no system type
deny
information. In this case, you can only access and manage the device through
the console port.
928
= Sets which database the switch uses to authenticate a user.
: local
1
2 : radius
: local then radius
3
4: TACACS+
5: local then TACACS+
6: radius then local
7: tacas+ then local
The IP address of the RADIUS server.
=
The RADIUS server's listening port number.
=
The system uses the default of 1812 if you do not specify a port.
The password for the RADIUS server.
=
The default account privilege assignment if the RADIUS server does not
=
send the service type information after user authentication is successful.
: Assigns the login accounts a low privilege level.
low
medium : Assigns the login accounts a medium privilege level.
high : Assigns the login accounts a high privilege level.
deny : Blocks access from this login account.
MSC1000G/1024G/1224G Series User's Guide