ZyXEL Communications MSC1024G Series User Manual page 940

Chapter 37 voip Commands
Table 351 voip Commands (continued)
COMMAND
sip numberplan
940
show <slot>
delete <name>
map [<name>]
set <name> <index>
[<pattern>
<rule>]
show [<name>]
DESCRIPTION
Displays the routing table for the
specified slot.
Removes the specified
numberplan table.
Displays the SIP call service
profile(s) that refer to the
specified numbering plan.
This command replaces the
pattern (the dialed number)
with the specified rule.
The system applies the rules in
numerical order, from 1 ~ 16, so
ordering is important.
index: The entry number (1 ~
16) in the numberplan table.
pattern: The dialed number for
which this rule applies.
Allowed characters are:
• Numerals "0" ~ "9"
• "x" (representing one digit)
• Asterisk "*" (representing one
or more digits)
• Period "." (representing zero
or more repetitions of the digit
or range preceding it, for
example "5." and "[1~3].").
• Tilde "~" (representing a range
of digits, for example "[3~9]").
The tilde must be used in
brackets, and characters to
either side of the tilde must
both be digits.
• Comma"," (representing a
choice of digits. for example
"[4,9]"). The comma must be
used in brackets, and
characters to either side of the
comma must both be digits.
• Pipe "|", separating number
plan patterns.
• Brackets "[" and "]"
(representing an allowed
range, for example "[1,3~5]").
• A maximum of one pair of
parentheses "(" and ")"
rule: The value with which the
pattern is to be replaced:
"\c": Countrycode.
"\d": National destination
(region) code/
"\1": The numbers enclosed
by the parentheses in the
pattern.
"deny": The pattern is not
allowed.
Displays the entries in the
specified numbering plan table.
MSC1000G/1024G/1224G Series User's Guide
P
L
M
L
M
L