Port Ipbpvc Domain Vlan Command; Ip Bridge Edge Router Commands - ZyXEL Communications MSC1024G Series User Manual

Chapter 31 port Commands
This command displays the settings for the specified domain and the VLAN that are in the
domain.
An example is shown next.
ras> port ipbpvc domain show
domain
------------------------------- ----------------------------------------
ISP1
example
The output values correspond to the input values of other IP bridge domain commands.

31.19.6 port ipbpvc domain vlan Command

Syntax:
port ipbpvc domain vlan <domain name> <vid> join|leave
where
<domain name>
<vid>
join|leave
This command adds the specified VLAN to (join) or removes the specified VLAN (leave)
from the specified domain. VLANs in IP bridges share the same VLAN space as regular
VLANs, so VLANs in IP bridges must have different VLAN IDs than regular VLANs. Use the
port ipbpvc VLAN command to configure the VLAN (see
You have to delete every IP bridge setting (including DHCP VLAN) that uses
the selected VLAN before you can remove it from the domain.
In the following example, VLAN 402 is added to domain "example".
ras> port ipbpvc domain vlan example 402 join

31.20 IP Bridge Edge Router Commands

Use these commands to set up and maintain edge routers in an IP bridge.
Edge routers are usually the gateways that are provided to the subscribers. They can also be
gateways that are specified in static routing table entries. Each edge router, in addition to its IP
address, has an associated VLAN ID. When the MSC forwards a frame to an edge router, it
uses this VLAN ID to replace whatever VLAN ID the subscriber specified.
722
vid
*101 102
The name of the domain.
=
The ID (<1..4094>) of the VLAN.
=
Specifies whether you want to add the specified VLAN to (join) or
=
remove the specified VLAN from (leave) the domain.
MSC1000G/1024G/1224G Series User's Guide
Section 31.27.10 on page 738).