ZyXEL Communications MSC1024G Series User Manual page 254

Chapter 11 Subscriber Port Setup Screens
Table 101 PVC Setup (continued)
LABEL
Priority
Mvlan
Select
Modify
Copy
Delete
VPI / VCI
PVID
Profile
MUX
Priority
Mvlan
Enable
Apply
254
DESCRIPTION
This field displays the priority value (0 to 7) that the line card adds to frames that come
in on this PVC without a (IEEE 802.1p) priority tag.
This field displays the PVC's current multicast VLAN setting. "-" indicates the multicast
VLAN is not active while "V" indicates the multicast VLAN is active.
Select a PVC's radio button and then use the Modify, Copy or Delete button.
Click Modify to display the selected PVC's settings in the fields above so you can edit
them.
Do the following to copy VLAN and PVC settings from one DSL port to another DSL port
or ports.
1. Use the Select column to choose a PVC which you want to copy to another port.
2. Click Copy to open the following screen.
Figure 154 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to copy
the settings. Click Select All to mark all of the port check boxes or click Select
None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Click Delete to remove the selected PVC.
Type the Virtual Path Identifier and Virtual Circuit Identifier for a channel on this port.
Type a PVID (Port VLAN ID) to assign to untagged frames received on this channel.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring must also be set to the fixed status in the VLAN.
Use the drop-down list box to select an ATM profile to assign to this channel.
Select the encapsulation type (llc or vc) for this channel.
Type the priority value (0 to 7) to add to incoming frames without a (IEEE 802.1p)
priority tag.
Select this option to turn on multicast VLAN for this PVC.
Multicast VLAN allows one single multicast VLAN to be shared among different
subscriber VLANs on the network. This improves bandwidth utilization by reducing
multicast traffic in the subscriber VLANs and simplifies multicast group management.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save on
the navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
MSC1000G/1024G/1224G Series User's Guide