Table of Contents
Advertisement
Sets the VOP card in slot 3 to use the VOP card at IP address 192.168.3.174 as the primary
signaling card and no secondary signaling card.
ras> voip h248 interface ip 1 172.16.19.200/24 1
Sets H.248 interface 1 to use IP address 172.16.19.200, subnet mask 255.255.225.0, and
VLAN ID 1. The active signaling card uses this IP address to communicate with the MGC.
ras> voip h248 interface slave 1 1 192.168.3.174
Identifies H.248 interface 1's media (slave) card 1 as using IP address 192.168.3.174.
ras> voip h248 interface mg set 1 MG1 MEGACO
Sets H.248 interface 1's MG name to MG1 and sets it to use the MEGACO H.248 profile.
ras> voip h248 interface mg enable 1
Has H.248 interface 1's signaling card start MG operation and register with the MGC.
ras> voip h248 interface group 1 3 0
Sets H.248 interface 1 to use the VOP card in slot 3 as the primary (active) signaling card
and no secondary (backup) signaling card.
ras> port h248 termination 3-1~24
Creates H.248 terminations for the ports on the VOP card in slot 3.
ras> port enable 3-1~24
Turns on the ports on the VOP card in slot 3.
37.7 Adding Another VOP Card voip h248 Command Example
Suppose you have already configured the previous example to use a single VOP card in slot 3
as both the signaling card and a media card. Here is an example of how to add a VOP card in
slot 4 as a second media card.
ras> voip ip set 4 192.168.3.175/24 2
ras> voip h248 opmode 4 mc
ras> voip h248 master 4 192.168.3.174 0.0.0.0
ras> voip h248 interface slave 1 2 192.168.3.175
ras> port h248 term 4-1~24
ras> port enable 4-1~24
Here is what each line in the example configures:
ras> voip ip set 4 192.168.3.175/24 2
Sets the VOP card in slot 4 to use IP address 192.168.3.175, subnet mask 255.255.255.0,
and VLAN ID 2. These settings are for the internal communications between the signaling
card and media card.
MSC1000G/1024G/1224G Series User's Guide
A301 1
A325 1
Chapter 37 voip Commands
949
Advertisement
Table of Contents
Troubleshooting
