Table of Contents
Advertisement
Chapter 15 Switch Screens
Table 261 Switch CFM > LBR (continued)
LABEL
State
Card Type
Up Time
Firmware
15.17.6 Switch CFM LBR Slot Screen
Click Switch > CFM > LBR and then the ID of a line card to display the screen shown next.
This screen lists whether loopback testing is enabled or disabled for each of the line card's
ports.
Figure 353 Switch CFM > LBR > Slot
The following table describes the labels in this screen.
Table 262 Switch CFM > LBR > Slot
LABEL
Port
Enable
504
DESCRIPTION
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Section 39.7 on page 974
for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it
was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
This field displays the number of the DSL port.
This field displays whether loopback testing is enabled or disabled on the port.
MSC1000G/1024G/1224G Series User's Guide
Advertisement
Table of Contents
Troubleshooting
