Chapter 34 switch Commands
The following example turns on the subtending 1 Gigabit Ethernet interface.
ras> switch port enable sub1
34.12.3 switch port flowctrl disable Command
Syntax:
switch port flowctrl disable <giga-port>
This command turns off flow control on a Gigabit Ethernet interface.
The following example turns off the flow control on the subtending 1 Gigabit Ethernet
interface.
ras> switch port flowctrl disable sub1
34.12.4 switch port flowctrl enable Command
Syntax:
switch port flowctrl enable <giga-port>
This command turns on flow control on a Gigabit Ethernet interface.
The following example turns on the flow control on the subtending 1 Gigabit Ethernet
interface.
ras> switch port flowctrl enable sub1
34.12.5 switch port frametype Command
Syntax:
switch port frametype <giga-port> all|tag
where
all|tag =
This command sets the specified port to accept all Ethernet frames or only those with an IEEE
802.1Q VLAN tag.
The following example sets ports the subtending 1 Gigabit Ethernet interface to accept only
tagged frames.
ras switch port frametype sub1 tag
34.12.6 switch port gvrp Commands
Use the
switch port gvrp
interfaces.
896
Specifies all Ethernet frames (tagged and untagged) or only tagged Ethernet
frames.
commands to configure GVRP settings for the Gigabit Ethernet
MSC1000G/1024G/1224G Series User's Guide