Table 110 IPB Interface (continued)
LABEL
Interface IP
NetMask
VID
Slot
Port
VPI/VCI
Select
Modify
Delete
Page X of X
Previous/Next
11.19 IPBPVC Screen
Use this screen to set up and maintain PVCs for subscribers in an IP bridge.
To open this screen, click Port > IP Bridge > IPBPVC.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
This field displays the IP address and the number of bits in the subnet mask that
define the range of IP addresses to which this downlink interface applies. If the
destination IP address of a packet is in this range, the MSC tries to forward the
frame to a subscriber in the specified VLAN and PVC, if any.
This field displays the VLAN ID the subscriber is in.
This field displays the number of the slot where the line card is located. It
displays "-" if the MSC looks for the subscriber in the whole VLAN and not a
specific PVC.
This field displays the number of the ADSL port on the line card to which the
MSC forwards frames. It displays "-" if the MSC looks for the subscriber in the
whole VLAN and not a specific PVC.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier
(VCI), if any. The VPI and VCI identify a channel on this port.
Select the radio button in the Select column for an entry and click Modify to be
able to edit the entry or Delete to remove it.
This identifies which page of information is displayed and the total number of
pages of information.
Click one of these buttons to show the preceding/following screen if the
information cannot be displayed in one screen.
Chapter 11 Subscriber Port Setup Screens
269