This command sets the packet type filter for the specified ADSL port(s).
The following example sets DSL port 4 of the line card in slot 5 to reject ARP, PPPoE and
IGMP packets.
ras> acl pktfilter set 5-4 arp pppoe igmp
21.11.2 acl pktfilter show Command
Syntax:
acl pktfilter show <slot>
This command displays the packet type filter settings on the specified line card's DSL port(s).
The following example displays the packet type filter settings for the DSL ports of the line
card in slot 5.
ras> acl pktfilter show 5
port filter
----- -------------------------------------
5- 1 accept-all
5- 2 accept-all
5- 3 accept-all
-------------------------- [snip] --------------------------
5-45 accept-all
5-46 accept-all
5-47 accept-all
5-48 accept-all
21.12 PPPoE Agent Information
Similar to DHCP relay option82, you can set the switch to insert line information into client
PPPoE Active Discovery Initialization (PADI) packets. This allows a PPPoE termination
server to identify and authenticate a PPPoE client based on the specified information (such as
the ISP name or line card number).
21.12.1 acl pppoeagent clearinfo Command
Syntax:
acl pppoeagent clearinfo <vid>
This command resets the PPPoE line description for subscribers in the specified VLAN.
MSC1000G/1024G/1224G Series User's Guide
netbios:
Reject NetBIOS packets. (Network Basic Input/Output System) are
TCP or UDP broadcast packets that enable a computer to connect to and
communicate with a LAN.
Reject IGMP packets. Internet Group Multicast Protocol is used when
igmp:
sending packets to a specific group of hosts.
Chapter 21 acl Commands
607