Vdsl Pvlan Setup - ZyXEL Communications MSC1024G Series User Manual

Chapter 11 Subscriber Port Setup Screens
Table 94 VDSL Port Setup: VLAN Setup (continued)
LABEL
Tag
Apply
Cancel
The table in the bottom half of the screen lists the VLANs that the port is a member of.
Modify
Delete
Index
VID
Registration
Tag
Select

11.8.9 VDSL PVLAN Setup

Click Port > VDSL in the navigation panel to open the VDSL Port Setup screen. Select a
VDSL line card ID, a port index number and click Setup (next to PVLAN) to open the
following screen. (Not all VDSL line cards support PVLAN.) Use this screen to configure
Protocol VLAN (PVLAN) settings for the VDSL port. PVLAN adds a VLAN ID and IEEE
802.1p priority to a specific protocol's untagged traffic.
Figure 143 VDSL PVLAN Setup
240
DESCRIPTION
Select the check box to tag all frames transmitted on this port with the port's VID.
Click Apply to save the changes in this screen to the system's volatile memory.
The system loses these changes if it is turned off or loses power, so use the
Config Save on the navigation panel and then the Save button to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring the screen again.
Click Modify to display the selected VLAN membership entry's settings in the
fields above so you can edit them.
Click Delete to remove the selected VLAN membership entry.
This is the number of the VLAN membership entry.
This field displays the number of a VLAN (VLAN ID) of which this port is a
member.
This field displays "fixed" to indicate that the port is a member of the specified
VLAN.
This field displays "V" if the line card is to tag all frames that are transmitted out on
this port with this VLAN group ID. It displays "-" if the line card does not tag all
frames that are transmitted out on this port with this VLAN group ID.
Select the radio button of a VLAN membership entry and then use the Modify
button or the Delete button.
MSC1000G/1024G/1224G Series User's Guide