Table of Contents
Advertisement
Chapter 10 Multicast Screens
Table 67 IGMP Port Setup (continued)
LABEL
Copy
ID
State
Card Type
Up Time
Firmware
10.3.2 IGMP Bandwidth Screen
Click Multicast > IGMP > Bandwidth to open the following screen.
198
DESCRIPTION
Do the following to copy IGMP port settings from one DSL port to another DSL port
or ports.
1. Select the radio button of the DSL port from which you want to copy IGMP filter
profile settings.
2. Click Copy to open the following screen.
Figure 114 IGMP Port Setup: Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the IGMP filter profile setting. Click Select All to mark all of the port check
boxes or click Select None to clear all of the port check boxes.
5. Click Apply to copy the IGMP filter settings to all of the ports that you have
selected in this screen. Click Cancel to close the screen without saving
changes.
This column lists the slot numbers of the line cards. Click the ID number of an active
line card to go to a screen where you can copy a DSL port's IGMP filter profile
setting to another DSL port.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could
be due to the card starting, a firmware upgrade in progress or a malfunction. See
Chapter 39 on page 969
for what to do if the line card stays stuck in the inactive
state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was
started.
This field displays the current firmware version installed on the line card.
MSC1000G/1024G/1224G Series User's Guide
Advertisement
Table of Contents
Troubleshooting
