Figure 158 Port Copy
The following table describes the fields in this screen.
Table 105 Port Copy
LABEL
Slot
Port
Copy
11.14 IP Bridge Overview
The IP bridge function is designed for large-scale, flat, access networks, and it is ideal when
the network is based on Ethernet. When the IP bridge is enabled, the system forwards frames
based on the destination IP address, instead of the destination MAC address, and it replaces
the source MAC address with its own MAC address.
MSC1000G/1024G/1224G Series User's Guide
DESCRIPTION
Select the number of a line card's slot.
Select the number of a DSL port on the line card.
Do the following to copy settings from one DSL port to another DSL port or ports.
1. Use the Slot and Port drop-down list boxes to select the number of the DSL
port from which you want to copy settings.
2. Click Copy to open the following screen.
Figure 159 Copy
3. Select a line card to which you want to copy settings.
4. Select the check boxes of the DSL ports on the line card to which you want to
copy the settings. Click Select All to mark all of the port check boxes or click
Select None to clear all of the port check boxes.
5. Click Apply to copy the settings to all of the ports that you have selected in this
screen. Click Cancel to close the screen without saving changes.
Chapter 11 Subscriber Port Setup Screens
259