You cannot enable both MAC count and MAC filtering on the same port at the
same time.
21.8.1 acl maccount disable Command
Syntax:
acl maccount disable <slot-port>
This command disables the MAC count limit on the specified DSL port(s).
The following example turns off the MAC count limit on DSL port 4 on a line card in slot 5.
ras> acl maccount disable 5-4
21.8.2 acl maccount enable Command
Syntax:
acl maccount enable <slot-port>
This command enables the MAC count limit on the specified DSL port(s). You can only
enable the MAC count filter on DSL ports that do not have the MAC filter enabled.
The following example turns on the MAC count limit on DSL port 4 on a line card in slot 5.
ras> acl maccount enable 5-4
21.8.3 acl maccount set Command
Syntax:
acl maccount set <slot-port> <count>
where
<count>
This command sets the limit for how many MAC addresses may be dynamically learned on
the specified DSL port(s).
The following example sets the MAC count filter to allow up to 50 MAC addresses to be
dynamically learned on DSL port 4 on the line card in slot 5.
ras> acl maccount set 5-4 50
MSC1000G/1024G/1224G Series User's Guide
=
Set the limit for how many MAC addresses that a port may dynamically learn.
For example, if you are configuring port 2 and you set this field to "5", then only
five devices with dynamically learned MAC addresses may access port 2 at any
one time. A sixth device would have to wait until one of the five learned MAC
addresses ages out.
The valid range is from "1" to "128".
Chapter 21 acl Commands
601